Builder Gel Flower Valeri №06

Description
Valeri Builder Gel Flower is a collection of builder gels featuring delicate coloured dried flowers, which lend a manicure a special charm and a light, floral feel. The gels are suitable for both nail extensions and for correcting and strengthening the nail plate.

This is a low-cure gel with a high degree of adhesion; it is firm and of medium viscosity (leaning towards thick), which means it self-levels well without running. The decorative flecks create a delicate, designer effect without the need for additional materials. It is easy to apply and holds the nail curve well.

Valeri gels are used in a three-phase system. Thanks to their comfortable consistency, they can be applied using a no-file or minimal-file technique.

Volume: 15 ml (brush not included).

Application technique:

Prepare the nail plate: remove any previous coating, carry out mechanical preparation of the nail, shape the nail and perform a manicure.
Degrease the nail plate using Valeri Nail Prep&Cleanser 3-in-1 and apply Valeri Dehydrator and Valeri Ultrabond.
Apply a base coat of Valeri Rubber Base or Valeri Cold Base to the entire nail and cure under a UV/LED lamp for 30–60 seconds.
Apply your chosen Valeri Builder Gel Flower using your preferred technique (extensions or strengthening) and cure it under a UV/LED lamp for 60–120 seconds.
File the shape and surface as required.
Apply your chosen Valeri Top and cure under a UV/LED lamp for 60–120 seconds.

When using Valeri Rubber Top, the dispersion layer must be removed 2–3 minutes after polymerisation. If necessary, file down the natural nail from the underside.
Notes:

use original lamps to ensure the correct application technique;
after curing, the material may have a tacky, sticky layer, which should be removed before applying colour or a top coat;
apply the gel in a thin layer near the cuticle to prevent lifting;
the properties of the materials depend on the ambient temperature. Please note that materials become thicker in winter and thinner in summer.
Warning! To avoid unwanted polymerisation of the material whilst working, testing or filming content, keep open bottles or brushes as far away as possible from daylight, especially direct sunlight. Please note that even on overcast days, clouds allow enough ultraviolet radiation through for the material to begin curing.
Curing: under a 48 W LED/UV lamp for 60–120 seconds per layer, depending on the thickness of the application.

Precautions: For professional use only. May cause an allergic reaction. Keep away from hot surfaces, open flames and UV light. Avoid contact with skin. Keep out of reach of children.

Storage conditions: Store at a temperature between +15°C and +23°C.

Shelf life: 24 months.